By: BuyDeutsch
Inserting Contacts into Plugs
STEP 1:
Grasp the crimped contact roughly one inch behind the contact barrel. Then hold the connector with rear grommet facing you.
STEP 2:
Push the contact straight into the connector grommet until a click is felt. A slight tug will confirm that it’s properly locked into place.
STEP 3:
Once all contacts are in place, insert the orange wedgelock. The orange wedgelock will snap into place.
Removing Contacts from Plugs
STEP 1:
Remove the orange wedgelock using a flathead screwdriver to pry it straight out.
STEP 2:
To remove the contacts, gently pull wire backwards, while at the same time releasing the locking finger by moving away from the contact with a screwdriver
STEP 3:
Hold the rear seal in place, as removing the contact will displace the seal.
Inserting Contacts into Receptacles
STEP 1:
Grasp the crimped contact roughly one inch behind the contact barrel. Then hold the connector with rear grommet facing you.
STEP 2:
Push the contact straight into the connector grommet until a click is felt. A slight tug will confirm that it’s properly locked into place.
STEP 3:
Once all contacts are in place, insert the green wedgelock. The wedgelock will snap into place.
Removing Contacts from Receptacles
STEP 1:
Remove the green wedgelock using a needle nose pliers to pull the wedgelock straight out.
STEP 2:
To remove the contacts, gently pull wire backwards, while at the same time releasing the locking finger by moving away from the contact with a screwdriver
STEP 3:
Hold the rear seal in place, as removing the contact will displace the seal.